Rear Duct Kit
For installations where the rear of the cooling unit will not have sufficient space and/or airflow, we offer duct kits to channel the hot air exhaust and cool air intake from ambient environments up to 100 equivalent feet (50' per duct).
Front Intake Kit
Our front intake kit allows our 1800 cooling unit to be installed directly above the wine cellar, with the cold air intake and exhaust passing through holes in the ceiling of the cellar.
Condensate Drain Line
We offer two ¼" ID condensate drain line options, one with and one without a 100W heating element to burn off excess moisture. Condensate drain lines are strongly recommended for wine cellar installations.
Power Cord Modification
If your power source is located inside the cellar, we can modify the power cord to exit from the front - rather than the rear - of the cooling unit.
CellarPro 1800 Air Filter
We offer commercial-grade air filters and magnetic frames that fit snugly over the condenser coils at the rear of the cooling unit. Using these filters, there are no more coils to clean!
Mounting Clips
Mounting clips can be used for bolting the front of the cooling unit to the ceiling (framing in the ceiling is required).
Compressor Heater
Our factory-installed compressor heater is required when the rear of the cooling unit will be exposed to temperatures below 40 degrees Fahrenheit.
Remote Display Control Kit
Our remote control kit allows the control panel to be installed in a remote location inside or outside the cellar. Wired to the cooling unit with low-voltage thermostat wiring, the remote control panel is perfect for cooling units that will be installed in hard-to-reach locations.
